Welcome to the online home of SWS Truck Bodies & Trailers

Michel's Transport Hopper Augers

 

 

 

 

These Hopper Auger Systems are easily detached by removing 5 bolts. Because each auger is equipped with a cleanout/ trap door, unloading at elevators, without removing the Hopper Auger system is accomplished

 

  

 

Transferring produce in fall is faster and easier. No auger positioning. Simply pull along side and unload into transfer auger.

 

The Hopper Augers are installed to incorporate a center delivery of two or more products in one stop.

One 8" auger has a similar output as a 10" air seeder auger.

Unloading with both 8" hopper augers has an unloading rate of 80 bushels per minute and will keep up to a 10" swing auger.

Unloading with both 10" hopper augers has an unloading rate of 140 bushels per minute and will unload at same rate as a 13" swing auger.

 

 

 

 

 The hydraulic requirement is 15 GPM with a 2500 psi bypass with a minimum 25 gallon reservoir. A 5.9 cubic inch hydraulic motor comes with a "manual" flow control valve to regulate speed. This hydraulic motor can be powered by adding into the loop of your existing hydraulic line on your air seeder, or by a hydraulic unit on your tractor/ semi truck

 

 

 A specially designed gearbox has a shaft angle and double ball bearings to provide years of dependable service

 

Make it easier yet by using a Wireless Remote that is offered as an option. Control your Hopper Augers from the top of your Air Seeder or Grain Bin. No more running up and down your air cart!!!

 

 

 

 

 

 

 

 

 

Hopper Augers Movie

 

 

 

 

 

 

 

 

Augers are available with center delivery for trailers with a minimum length of 31'. The clearance underneath the auger after installation is 14" on most trailers. The hydraulic requiremnt is 15 GPM with a 2500 psi bypass. Unloading rate is approx. 300 bushels/minute per auger. Hopper auger depth is 9".
This system can be used with an airseeder loading auger. The down spout is attached to a 7" auger system. This hopper auger system is mounted so that the auger heads do not protrude past the side of the trailer.
This 5.9 cubic-inch hydraulic motor comes with a flow control valve to regulate speed. The motor is reversible, allowing easy clean out. The hydraulic motor can be powered by T-ing on the existing hydraulic line on the airseeder, or on the semi tractor unit.
The hopper augers are easily detached by removing 5 bolts. The trap door can be opened to allow for easy unloading at elevator.
This system can be used as a transfer auger in the fall. Unloading with both "hopper augers" will keep up to a 10" auger. Total weight of one set of hopper augers is 220 lbs. The specially designed gearboxes have a shaft angle and ball bearings to provide years of dependable service.
   
Optional electric solenoids are available with elcectric switch or wireless remote.